®™ Welcome to Strike Force Hobbies New Official Website. Preferred by modelers worldwide dedicated customer service
OFFICIAL DISTRIBUTOR FOR NORTH AMERICA AND CANADA !
Includes grass,concrete,planking textures,grass mat, and 4 bags of littering material.
The grass mat is 11,5 by 8,5 inches (30x21cm).
The bags contain sufficient sand, bright grass, dark grass and foliage
The textures are printed on super-heavy 300g cardboard. Everything you need for your aircraft diorama display.
This is a Guide only :
There are two ways to render the "panel lines" between the concrete plates:
You can just apply thin lines of the white glue,sprinkle the litter on it and blow away all the excess. In case you need some more, just repeat the process again at the proper position. If you have applied too much,just "weed out" a little bit until desired effect is reached.
The entire build displayed below took on average 2.5 hours.
Some noted Improvements you may want to apply :
Uschi recommends to apply some of the littering material also on the grassy area.To provide a good grip for the litter, Uschi recommends to thin some white glue with water and spray over the grassy texture.
Sprinkle littering material on these areas and letting it set. Repeat this step in several layers until you are satisfied with the final result.
Also you may want to add fine sand and pigments.
The printed sheets might be a bit glossy due to the production methods applied. Spray a thin coat of flat clear to reduce this effect.Consider the effective application of pigments and airbrush-shading effects on the sand,concrete,planks,and grass to obtain your desired effect.
Final result finished build :