®™ Welcome to Strike Force Hobbies New Official Website. Preferred by modelers worldwide dedicated customer service

OPENFORBUSINESS2017   OFFICIAL DISTRIBUTOR FOR NORTH AMERICA AND CANADA ! 

  NEW2016PAYPALLOGO.jpg

 

ULTIMATENEWLOGO2019

ULTIMATE BURNISHING LIQUID VIDEO & FULL INSTRUCTIONS

PLEASE FOLLOW FULL INSTRUCTIONS CAREFULLY AND ALWAYS ENSURE YOU WEAR FULL EYE AND HAND PROTECTION WITH THIS PRODUCT

INSTRUCTIONS FOR USE,ALWAYS WEAR EYE AND HAND PROTECTION WHEN HANDLING OR WORKING WITH THIS PRODUCT

PRODUCT IS NON-FLAMMABLE

FOLLOW INSTRUCTIONS CAREFULLY FROM TOP TO BOTTOM AND IN SEQUENCE.

  • Ensure the tracks are fully cleaned and degreased using water & washing up liquid and then dried thoroughly.

  • Wearing protective gloves, pour the Ultimate Burnishing Liquid into a plastic container large enough to fully immerse the tracks Add 100ml - 125ml of plain tap water (you can use the now empty UMP Burnishing Liquid bottle for this) and mix thoroughly.

  • Immerse track links in the solution, making sure they are fully covered.

  • Move the tracks around to ensure all areas are treated and agitate using a stiff brush (a toothbrush is good for this) to ensure the fluid reaches the inner parts of the tracks. Don't forget to treat spare track links too.

  • If treating the links when unassembled, use two separate smaller containers with sealed lids. Add half a bottle of burnishing liquid and 50ml of water to each tub. Put the lid on and shake the tub well to mix.

  • Remove the tracks once the desired effect/colour has been achieved. You can vary this by leaving them in the solution for longer or shorter periods. 7 to 30 minutes treatment should give the desired effect.

  • Immediately run the tracks under running water to neutralise any remaining fluid, then fully dry the tracks.

  • Now treat with your desired Ultimate washes and pigments, then seal with a matt varnish.

  • Run an Ultimate sanding sponge along the raised surfaces to give a worn bare metal look if desired For smaller vehicle tracks you may not need to use the full bottle of fluid, adjust for the required amount.

    THIS INSTRUCTION VIDEO IS COPYRIGHT OF ULTIMATE MODELLING PRODUCTS AND INTERNATIONAL SCALE MODELLER ALL RIGHTS RESERVED